Profile: 18+ Years of experience as Embedded Hardware and System Design Engineer. I have executed Processor & FPGA based High-Speed Mixed signal board design for Consumer, Medical, and Telecom domain products and have a strong knowledge base in the complete product development life cycle.
Having very good hands-on exposure with,
• System Architecting & High-speed board design
• Freescale (T1024, MPC 8540), ST micro (Spear1340), Marvell Kirkwood Processor Design
• Xilinx – Virtex 5, Artix-7; Altera-Stratix 3 FPGA Design
• Flash, DDR2, DDR3, DDR3 Module, DDR4 SDRAM Design
• High-Speed Interfaces Design – Gigabit Ethernet, PCIEx, LVDS, SGMII, USB
• Standard Interface Design- I2C, SPI & UART
• Board and System Power Budgeting
• Schematic Capture- OrCAD and Allegro Concept HDL
• Layout Guidelines and Review – Stack up, Placement, High-speed routing, power planning, and Mechanical Constraints
• Signal and Power Integrity – Pre-& Post Layout – Reflection, Cross talk, Eye Mask, DC Drop, Target Impedance, Decoupling Analysis,
• Liner & Switching Power regulator selection and design – Power Rail Sequencing, Load regulation, Ripple Measurements, Transient response, Step Load Measurements.
• Assembly & Bill of Material (BOM) Procurement Process flow
• Fabrication Process
• EMI/EMC Compliance Testing- Medical & Telecom Products – IEC60601-1, IEC60601-2, IEC60601-2-47, EN55032(CISPR 32)- IEC61000-4-2,3,4,5,6,8,11.
• Electrical Design Validation Testing- Timing and Signal Parameter Measurements, Eye capture, and Mask Analysis
• Test equipment- Infinium MSO9404, Tektronix DPO (16G), multimeter, Components soldering for test and debug
• Medical Grade Product CE certification process based on ISO13485 -Medical Product Quality
Management System (QMS) Process Flow & ISO14971 Risk Management Process Flow
• Proposal and technical requirement documentation
• User manuals
• Test Plan and Report documents
• ATE Board development for Flux, Catalyst, and Fusion-HFi Templates on Agilent/LTX testers